For so many times for using Laser Machines, Cutting Grid should be cleaned carefully to make sure perform well. This post would guide you to clean the Vector Cutting Grid, you just follow our step to make itWe use a bucket below to soak the vector grid. We need a wide soak to make it easy to clean. It’s far more shallow requiring less cleaning solution. You can find a kennel tray at your local pet store and buy it for this cleaning
Are you ready to soak it. Gently place the grid in your soaking container for about 5 minutes. DO NOT soak for longer than 5 – 10 minutes as too much exposure can harm the vector grid. You will see the solution immediately starts to dissolve the residue on the grid.
Next you may use a pipe cleaner or small plastic brush to remove any tough debris that was not removed from the vector grid. Just dip the instrument in the solution and gently swab the area.
The last step is to make it dry in the ventilation air. The advice is that do not expose it to strong sunlight, it’s not good for quality of grid